How to Properly Replace a Dead Jeep Battery
Jeep batteries typically last between three and five years. If you notice any warning signs of a battery going bad, it is important to get it replaced as soon as possible.
Replacing a battery can be tricky as vehicle hood space continues to shrink in order to improve performance. Check your Jeep owner’s manual for detailed information on where the battery is located.
Symptoms of a Dead Battery
A dead battery in your Jeep can leave you stranded and without power for all of the vehicle’s electrical components. It’s a good idea to learn the early symptoms of a battery problem in order to take corrective action before it’s too late.
Slow Engine Crank
The most common early symptom is a slower than usual engine crank when you turn the key to start your car. A weak battery can’t provide enough power to the car’s engine to turn over properly.
You may also notice that your car takes longer than normal to turn on its headlights when you activate the ignition. The headlights won’t go on at all if the battery is dead.
A sour smell, similar to rotten eggs, is another clear sign that the battery needs replacing. jeep battery This odor is caused by the battery leaking gas and sulfuric acid, which poses a health hazard for you and your passengers.
If your battery is getting close to the end of its life, you can try to revive it by jump-starting it with a working car. Park the other vehicle next to your Jeep and connect one of the jumper cables from the working car’s positive clamp to the dead battery’s positive terminal. Then, connect the other end of the cable to an unpainted metal spot like a clean bolt on the dead car to ground it.
Cost of Replacing a Battery
Incorporating routine maintenance practices, such as cleaning battery terminals and inspecting batteries cables, can help extend the lifespan of a car or truck battery. However, eventually your Jeep’s battery will reach the end of its useful life. If it does, it’s best to have the battery replaced by a professional as soon as possible.
The cost of a Jeep battery depends on the type of battery and where you get it installed. For example, a deep-cycle battery with ev battery companies high cranking amps and reserve capacity may be better suited for your Jeep if you use it for off-road driving or powering large electrical accessories like a winch, refrigerator or auxiliary lighting. Our talented auto technicians can help you select the right battery for your vehicle.
Replacing your battery can be easy if you follow the recommended steps. First, make sure your engine is turned off and all electrical components are disconnected. Locate the positive battery cable (usually red) and remove it. Disconnect the negative battery cable next (usually black) by loosening or unscrewing it with a wrench or ratchet. Avoid using substantial force or metal tools as this could damage the cable and cause sparking that can ignite the dead battery’s electrolyte fumes.
After disconnecting both battery cables, remove the battery and clean the battery tray and posts with a proper battery cleaning solution or a wire brush. Before installing the new battery, connect the red clip to the red POS post on the good battery and attach the black clip to the black post of the dead battery or a clean, non-painted metal surface under the hood.
How to Replace a Battery
The battery is a crucial component that powers your vehicle’s engine and electrical components. It is important to change your battery every four years or so because it will eventually fail and become too weak to power your car’s systems. A bad battery can lead to a number of issues, such as a slow start or even total loss of power. The good news is that replacing your battery is a simple task that you can do yourself.
First, you will want to ensure that your Jeep is turned off and the hood is open. Next, you will need to remove the battery hold down clamp. This is usually located behind the battery in the tray, and you will need a ratchet with an extension and 10mm socket to loosen the bolt and reach in to pull out the clamp. Once you have removed the clamp, simply lift the battery out of the tray and set it aside.
Once you have removed the old battery, you will need to install the new one. Make sure that you have the correct battery size and type for your Jeep, and that it fits in the tray properly. You will also want to make sure that the positive terminal and negative terminal are connected correctly. Once you have done this, you can close the hood and connect the battery cables.
Warranty Information
Your Jeep is a powerful and reliable vehicle that will get you where you need to go for years to come. As such, you need to ensure that your vehicle is protected against defects in materials and workmanship by obtaining an extended warranty from the manufacturer. Most new vehicles offer a basic limited factory warranty for three years, while some electrified models may have a longer powertrain warranty.
In addition to these warranties, you can also obtain a battery replacement warranty from the dealer or Mopar. These warranties offer extra coverage for specific components that could break or wear out early, and they are essentially an insurance policy against expensive repairs. These policies are often cheaper than buying the manufacturer’s bumper-to-bumper or powertrain warranty, but they do not cover items added or replaced after your vehicle left the assembly plant.
Fortunately, most car batteries last between three and five years, so you should replace your Jeep battery when it is nearing the end of its lifespan or shows signs of weakness. A skilled auto technician can help you select the right battery for your vehicle based on its application, driving habits, and other factors. You can also speak with an associate at our dealership for additional information about the car battery options available for your vehicle. Incorporating maintenance practices, such as keeping terminals clean and inspecting the battery cables regularly, can help extend your battery’s lifespan.
